# Equivalent Circulating Density (ECD) Using Yield Point for MW More than 13 ppg

Another equation to determine equivalent circulating density is to use yield point.

This formula below is used to calculate the ECD and it is good for mud weight more than to 13.0 ppg

Where:

ECD is equivalent circulating density in ppg.

MW is mud weight in ppg.

Hold ID is inside diameter of hole in inch.

Pipe OD is outside diameter of pipe in inch.

YP is mud yield point.

YP can be calculated by these following equations.

YP = Reading at 300 rpm – PV

AV is annular velocity in ft/min

AV can be determined by the following equation.

AV in ft/min = (24.5 x Q) ÷ (Dh2 – Dp2)

where

Q = flow rate in gpm

Dh = inside diameter of casing or hole size in inch

Dp = outside diameter of drill pipe, drill collars, or tubing in inch

Determine the ECD with the following information

MW = 13.5 ppg

Hole diameter = 6.2

Pipe diameter = 4

Flow rate = 200 gpm

AV in ft/min = (24.5 x 200) ÷ (6.22 – 42) = 218.4 ft/min

PV = 40 – 25 = 15

YP = 25- 15 = 10

ECD = 14.2 ppg

If you have mud weight less than 13 ppg, please read this article ” Equivalent Circulating Density (ECD) Using Yield Point for MW less than 13 ppg

Equivalent Circulating Density (ECD) in ppg

Equivalent Circulation Density (ECD) with complex engineering equations

Effect of Frictional Pressure on ECD while reverse circulation

Effect of Frictional Pressure on ECD while forward circulation

### Related Post

Kick Tolerance Factor Calculation The following formula is the kick tolerance factor. Where; Casing shoe TVD in ft Well depth TVD in ft Maximum Allowable MW in ppg Cur...
Determine the actual gas migration rate You have learned how to estimate the gas migration rate. Today, I would like to show you how to figure out the actual gas migration rate after you shu...
Boyle’s Gas Law and Its Application in Drilling Understand Boyle’s Gas Law Boyle’s law states that at constant temperature, the absolute pressure and the volume of a gas are inversely proportiona...
Volume of Mud Increases due to Adding Hematite The concept of mud volume increase due to adding Hematite is as same as the mud volume increase by adding barite and calcium carbonate. The formula fo...
Share the joy
• 11
•
•
•
•
•
•
•
•
11
Shares

Working in the oil field and loving to share knowledge.

### 8 Responses to Equivalent Circulating Density (ECD) Using Yield Point for MW More than 13 ppg

May I ask , Do you use formulas in the field ??

2. tulio says:

I think this formula can’t be used in the field because you may have several pipe sections like DC, HW, 5″ DP , 4″ DP , 3.5″ DP and so on , so the ECD will be different around every pipe section.
I think the best formula for ECD to use is that one based on annular pressure loss.

• This is one of the empirical equations used to calculate ECD. It just give you rough figure which might not be accurate as real measurement (PWD).

3. kresimer zubac says:

I think this formula is not accurate

• This formula is just for rough estimation so you will get an ideal how much ECD is.

4. khalil says:

This formula does not include pipe length and well depth.

• This is a quick calculation that you can use a simple calculator to estimate the ECD.

This site uses Akismet to reduce spam. Learn how your comment data is processed.