Water Phase Salinity of Oil Based Mud

Water phase salinity is a factor showing the activity level of salt in oil based mud. In order to control the water phase salinity, salt is added into the drilling fluid. The salt added into the system will be dissolved by water in the mud; therefore, the chloride content will increase.

By increasing the chloride concentration (adding salt), the activity level in the mud will decrease. Salt is added in order to create an activity level which is equal to or less than formation water. Therefore, the water phase in the mud will not move into formation and cause a clay swelling issue. Practically, calcium chloride (CaCl2) or sodium chloride (NaCl) is the chemical to be used.

When salt must be added into the mud system?

 

Typically, while drilling with oil based mud, cuttings are generally dry, hard, and easy to break into pieces. However, if the cuttings come together in big pieces and are wet, it may increase salt content in the drilling fluid. The reason is that water in the mud moves into formations and swells the clay particles in the formation. Swelled clay causes wet and mushy cuttings.

References

Andy Philips, 2012. So You Want to be a Mud Engineer: An Introduction to Drilling Fluids Technology. Edition. CreateSpace Independent Publishing Platform.

Bourgoyne, A.T. (1986) Applied drilling engineering. Richardson, TX: Society of Petroleum Engineers.

Mitchell, R.F., Miska, S.Z. and Aadnoy, B.S. (2012) Fundamentals of drilling engineering. Richardson, TX: Society of Petroleum Engineers.

Ryen Caenn, 2011. Composition and Properties of Drilling and Completion Fluids, Sixth Edition. 6 Edition. Gulf Professional Publishing.

Related Post

Types of Flow and Rheology Models of Drilling Mud When you learn about drilling mud, the rheological models are essential knowledge. The rheological models are critical for a drilling fluid study beca...
Total Hardness and Chloride Content in Water Based... “Total Hardness” or “Water Hardness” is a measurement of calcium (Ca2+) and magnesium (Mg 2+) ions in water base mud. The total of both soluble ions o...
Determine Quantity of Material Used in Mixing a Si... This is a simple example to demonstrate how to determine quantity of material required in a simple mixing system. Let's learn from the example below. ...
Solid Content in Drill Mud Solid content is a fraction of the total solid in drilling mud, and it always increases while drilling ahead because of drilling solid (cuttings), mud...
Share the joy
  • 148
  •  
  •  
  •  
  •  
  •  
  •  
  •  
  •  
    148
    Shares
Tagged , , , , , . Bookmark the permalink.

About DrillingFormulas.Com

Working in the oil field and loving to share knowledge.

2 Responses to Water Phase Salinity of Oil Based Mud

  1. Uthman Lukman says:

    nice one!?

  2. Rahul Sancheti says:

    Very good and clear information. Thank you.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.