Lag Time for Drilling Business and How to Calculate Theoretical Lag Time

Lag time is traveling time interval required for pumping cuttings from each particular depth to surface. It can be expressed in terms of time (minutes) and pump strokes.



The lag time always changes when a well becomes deeper and/or pumping speed change. Two factors, affecting lag time calculation, are annulus volume of drilling fluid in and drilling mud flow rate.

With certain annular volume, the lag time, normally expressed in minutes, can be determined by dividing the annular volume (bbls) by the flow rate (bbl/min).

If there are changes in mud flow rate, the lag time figure will be changed as well. In order compensate for any changes, the lag time is transformed into pump strokes too; therefore, a change in speed of pump will not affect the lag time.

How to Calculate Theoretical Lag Time

There are 3 steps to do in order to calculate lag time as listed below;

1. Calculate pump output
2. Calculate annula
r volume at certain depth of hole
3. Calculate the theoretical lag time

Oilfield Unit

Example – Determine lag time from bottom to surface with the following information;

Bit depth = 9500’ MD
Pump rate = 300 GPM
Annular volume at 9500’ MD = 250 bbl
Triplex pump output = 0.102 bbl/stroke

Solution;

Pump rate = 300 GPM ÷ 42 = 7.14 bbl / minute
Lag time in minutes = 250 bbl ÷ 7.14 bbl / minute = 35 minutes
Lag time in strokes = 250 bbl ÷ 0.102 bbl/stroke = 2451 strokes

Metric Unit

Bit depth = 3,300 m
Pump rate = 1,200 liter/min
Annular volume at 3,300 m = 40 m3
Triplex pump output = 0.01622 m3/stroke

Solution;

Lag time in minutes = 40 m3 ÷ (1,200 ÷ 1,000 m3/ min) = 33.3 minutes
Lag time in strokes = 40 m3 ÷ 0.01622 m3/stroke = 2466 strokes

Download Lag Time Calculation Spreadsheet

Ref books: 

Lapeyrouse, N.J., 2002. Formulas and calculations for drilling, production and workover, Boston: Gulf Professional publishing.

Bourgoyne, A.J.T., Chenevert , M.E. & Millheim, K.K., 1986. SPE Textbook Series, Volume 2: Applied Drilling Engineering, Society of Petroleum Engineers.

Mitchell, R.F., Miska, S. & Aadny, B.S., 2011. Fundamentals of drilling engineering, Richardson, TX: Society of Petroleum Engineers.

Tagged . Bookmark the permalink.

About DrillingFormulas.Com

Working in the oil field and loving to share knowledge.

5 Responses to Lag Time for Drilling Business and How to Calculate Theoretical Lag Time

  1. Alexander says:

    Why you didn’t use rheology of the mud?

  2. Yasir says:

    Can I Have The resource book please ?

  3. moussa says:

    where does 42 come from in the calculation?

Leave a Reply to Alexander Cancel reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.