J-Lay pipeline installation method is frequently used in deep water pipeline installation. The curvature of pipe line is similar to J shape (Figure 1) while the subsea pipeline is being installed. J-Lay method can handle a full range of pipeline size and it is particularly suitable for deep water pipeline installation up to 2,000 m (6,560 ft). Furthermore, the J-Lay method can withstand higher underwater current and sea state than the S-Lay method.
The J-lay method puts less stress on the pipe line because the pipeline is installed in an almost vertical position. Whereas the S-lay method puts on more stress due to two curvatures at the sag bend and over-bend region. The pipeline is sent into water at a small angle reference to a vertical line and continues at a steep angle until a sag bend is formed.
Figure 1- J-Lay pipeline vessel
This works very well in deep water environment where distance from a vessel to a touchdown point is quite far because sag bend is not too much. If the short distance from a vessel to a touchdown point. Continue reading
