Possible Wellbore Problems during Well Kill Operation

In the previous article, Common Problems and Complications During Well Kill Operation, it is about commons complications that can be possibly seen while performing well control operation. For this article, it will discuss other wellbore problems which are stuck pipe, surface pressure reaching to MAASP, lost of control and hydrate.

Stuck Pipe

During a well control operation, a stuck pipe can occur and this has the potential to lead to serious issues. Whenever the pipe is off bottom, the chances of the pipe getting stuck increases. Therefore, rotating the pipe should reduce the risk of this problem occurring. However, with the well shut it, it is impossible to rotate to minimize stuck pipe so the stuck pipe should be dealt after the well is properly secured.

Throughout well control operation, wellbore pressures will be high and this means the most common cause of a stuck pipe comes from differential sticking. However, this isn’t to say mechanical sticking can’t occur if the hole sloughs and packs-off after coming into contact with the influx fluids.

Operation can normally continue when the pipe is differentially stuck (with the bit on bottom) because the well can still be killed with circulation. Once the well is killed, then the pipe can be free safely later.

When the bit is off bottom and the pipe becomes differentially stuck, this is a more complicated scenario since it’s more difficult to reduce wellbore pressure; at that depth, it’s normally impossible to achieve a reduction by circulation. Although there may be opportunities to spot a freeing agent and free the pipe, volumetric control is the chosen method if the influx was swabbed in.

When the pipe is mechanically stuck, the pipe can be freed by spotting a freeing agent and working the pipe (by combining the two, the desired result is achievable!).

Stuck Pipe due to Differential Sticking

Figure 1 – Stuck Pipe due to Differential Sticking

Continue reading